Omni Power

.

Omni-Power shocks with Tilyte Technology feature qualities only found in the most elite suspensions on the market. Developed by Omni-Power, Tilyte is a system of components that works together symbiotically to create a unique blend of damping, which allows a much better foot print over virtually any road condition. We offer a 2 year warranty on all of our suspension systems.

.

As many of you know there are a million aftermarket companies out there that manufacture coilovers, However that does not mean that all kits are created equally! Many of these companies cut corners by using cheap, inexpensive materials to reduce their overall costs. This is not the case with Omni-Power coilovers which are made using nothing but the highest quality materials resulting in a coilover kit that out performs and outlasts all of the competition!

.

Omni-Power front camber kits are designed for vehicles that are in need of both adding and removing camber. Great care was taken to adjust the angle of the ball joint mount to allow adequate room for lowered vehicles.

.

Unique only to the Omni-Power product line, our light weight front lower control arms (FLCA's) are forged with certified T6-2014 aluminum (100% stronger than 6061-T6). Pure polyurethane bushings are used that wont squeak or crack like other poly bushings that use fillers to cut costs. Each control arm is then hard anodized to eliminate corrosion and maintain a show quality look.

.

Omni-Power lightweight rear lower control arms (RLCA's) are manufactured in the USA using aerospace grade T6-6061 aluminum. We use 2 piece 100% pure polyurethane bushings that won’t squeak or crack like other poly bushings, which use fillers to cut costs. Each control arm is then hard anodized to eliminate corrosion and maintain a show quality look. Typical weight savings is approximately 4+ pounds depending on the vehicle model.

.

Omni Power USA 4 Bar MAP (Manifold Absolute Pressure) sensors use state of the art bipolar op amp circuitry with thin film resistor networks built into each micro chip. Pressure changes are calculated on a true linear 0-5 volt scale via a specially designed silicon pressure sensor that also compensates for temperature changes. The unique ability to compensate for temperature changes allows the Omni Power USA 4 Bar MAP sensor to remain a minimum of 99% accurate from 32 degrees F to 180 degrees F through out its range of scale. With the true linear pressure vs. voltage scale there is never a need to re-tune at different altitudes as with other sensors.

.

Omni-Power Throttle Position Sensor replaces the OEM TPS Sensor without any modifications. The Honda dealer only sells the TPS sensor along with the Throttle Body and it cannot be purchased seperately.

.

• Removable steering wheel system to make it easier to get in and out of your car... just like pro-race cars. • Remove your steering wheel for added security against car theft. • Great for show cars too.